Garment factories use several inspection points because a defect costs more the later it is found. A wrong stitch caught at the machine takes seconds to fix. The same stitch found in a packed carton can mean unpacking, reworking, repressing and repacking.
Inline inspection
Inline checks happen while the garment is being made, at or near the operation.
- Who: operators checking their own work, plus roving quality checkers or supervisors.
- When: at the start of a run, after every change of operation, machine, needle or operator, and at regular intervals afterwards.
- What: stitch density, seam allowance, stitch type, threads, alignment of parts, measurements of key components.
- Why it matters: it stops a defect from being repeated across hundreds of pieces. It is the cheapest control in the factory.
A useful habit is first-piece approval. Before an operation runs in volume, the first garment is checked against the approved sample and spec. Nobody starts a lot on assumption.
End-line inspection
End-line checks are done on garments at the end of the sewing line, before they move on to finishing.
- Who: dedicated checkers, one per line or per group of operators.
- What: every piece, looked at in a consistent order, for sewing defects, open seams, skipped stitches, uneven hems, loose threads, stains and obvious measurement problems.
- Output: defect counts by type and by operation, fed back to the line the same day.
End-line is usually a 100 percent check, so it is a sorting step. Its real value is the data: if one defect appears repeatedly, the cause sits upstream and the checker's report should trigger action, not just rework.
Final inspection
Final inspection is done on finished, pressed and packed (or nearly packed) goods.
- Who: the factory's final quality team, and often the buyer's own inspector or a third party.
- What: random samples under a plan such as AQL: appearance, measurements, labelling, folding, packing assortment, carton marking, and sometimes functional and metal-detection checks.
- Output: a pass or fail decision on the lot, and a report.
Final inspection is a verification, not a cleaning step. If many defects are found there, the earlier controls did not work.
How the three fit together
- Inline prevents.
- End-line sorts and gives fast feedback.
- Final verifies and releases.
Skipping one overloads the others. A factory with weak inline control relies on end-line repair. A factory with weak end-line control meets final inspection with a high failure risk.
Questions to ask about your own system
- Is first-piece approval documented, and who signs it?
- Do end-line checkers use the same defect list and class definitions as the buyer?
- Are defects recorded by operation, not just in total?
- Does the supervisor see the report before the next shift starts?
- Do pressing and finishing have their own checks, since many defects such as shine marks and stains appear there?
Mistakes to avoid
- Checkers who are also under pressure to meet output targets.
- Defect lists that are too long to use. Eight to twelve key defects per product type is easier to enforce.
- Rework that goes back into the line without a re-check.
- Final inspection run only when the shipment is already late.
Good inspection is about information moving quickly: from the checker to the operator, from the supervisor to planning, from the final report to the next order's pre-production meeting.
One more point: inspection staff need authority as well as training. If a checker can be overruled whenever a line is behind target, the system records problems but does not stop them. Give checkers a clear right to hold a bundle and escalate, and back them when they use it.